The Original Saw Company

Original Saw’s Pneumatic clamping systems allow for a variety of clamping applications. The below listed items consist of cylinders clamping the material back against the fence or over center cylinders clamping the material against the table top, or a combination of both. The front firing cylinders are mounted on adjustable slide carriages with locking handle to adjust to any material width. The over center clamps are mounted behind the fence and when not clamped are fully behind the fence to allow for clear loading and unloading of the machine.

900500-00

Pneumatic clamping system
2 cylinders clamp against fence

900500-01

Pneumatic clamping system
2 cylinders clamp against fence
2 cylinders clamp against table

	Rear Pushing cylinder (presses against fence)
	Over Center Clamp (presses down on table)

Original Saw Company has furthered its clamping systems with the 900500-02 over arm clamping system. This system is for clamping many smaller components at one time. The components of this system include 2 rear firing cylinders that line up the material with the fence and the over arm clamp that pulls down to clamp the material down on either side of the blade. The over arm clamp is adjustable up and down to allow different sized material to be clamped and cut.

900500-02

Pneumatic Clamping System over arm clamp and 2 rear pushing cylinders

Multi-Part over arm clamping system